Bathroom Tile / January 3, 2019 / Amie Thibault
If you decide to replace the entire set of tiles in the bathroom, the first thing that you need to do is scrap off the existing tiles with a floor scraper. It is easier to do so by hitting the tiles with a hammer in the center. Once the old bathroom tiles have been removed, properly scrape out the adhesive that was used to fix these tiles with an angled steel head tool.
Start Installing Your Tiles. This is the last step. In this step you should spread some adhesive onto the floor. Position the tiles and cut them around the corners of the room. Use your gloves so you do not get too messy. Put a tile separator in between as you wait the adhesive to dry up. After that, remove the separator and spread the grout. Let it dry and you are ready.
You MightAlso Like
Ours Editor Picks ofThe Week